How do you unclog a Hamilton Beach FlexBrew?
Unplug the coffee maker. Take out the top part with the needle and stick a paper clip inside of the portion that looks similar to a sewing needle. Run it under hot water to make sure there are no loose particles still in it. Dry it out, put it back on the coffee maker, and plug it back in. Unclogging Needle Unplug coffee maker and allow to cool. Bend a small paper clip. Insert tip of paper clip through hole of the piercing needle and up into shaft of piercing needle to ensure grounds have been removed. Rinse.
How do I reset my Hamilton Beach iron?
Turn unit off, unplug the iron from the outlet and plug back in, turn unit on. Press the reset button on the control panel. If your iron has no power, Cord Inspection: Examine the power cord for any signs of damage such as fraying, cuts, or exposed wires. If the cord is damaged, it may need to be repaired or replaced. Fuse or Circuit Breaker: Check if the circuit breaker or fuse for the outlet has tripped.Verify that the iron is plugged in and that the outlet is working. Is the Temperature Settings button set on a fabric setting? Iron may have shifted to Auto Off (blinking red light). Push “settings” to restart and adjust to desired temperature.
Why is my Hamilton Beach coffee maker not working?
Clean the brew basket and water reservoir to remove clogs or mineral buildup. Inspect the start button for debris or damage. Reset the machine by unplugging for a minute. If the heating element works but no brew starts, the control board or sensor may need professional inspection or replacement. If your coffee machine is powering on but not brewing, the culprit might be a blocked water line or heating element. Mineral buildup from hard water can clog these components, preventing the water from reaching the right temperature or flowing into the brew basket[^2^].A damaged button or a blown fuse could be the culprit in your coffee maker not turning on.You may have buildup in the tank seal. Turn the brew tank upside down over the kitchen sink, then press the dispensing valve (on the bottom of the tank) and flush with water for 30 seconds.Brew Cycle Will Not Start Check the electrical outlet to ensure that it is working as well. Also check that the ON/OFF switch is turned to the ON position. Water tank empty – If the water tank is not filled with water the brew cycle will not start. Make sure you add enough water to the machine but do not overfill.