Can I damage my Nespresso by descaling?
Nespresso recommends descaling every 3 months or 300 capsules (whichever comes first). Nespresso machine. There’s even a cleaning cycle you can run with just water that only takes a few minutes. Here’s everything you need to know about how to clean (and descale) your Nespresso machine.So if you’re using hard water, give your machine a bit of TLC and take 20 minutes every month or two to clean and descale it. Like any appliance, your Nespresso® machine needs some maintenance to extend its life and maximize performance, thus ensuring your coffee tastes even better.The descaling agent is tough on limescale build-up but gentle on the machine, which helps your Nespresso perform at its best and extends its lifespan.After descaling your Nespresso machine, run at least two full water-only cycles without coffee pods. Fill the water tank with fresh, clean water each time. This flushes out any remaining descaling solution from the internal pipes and heating element. Avoid using soap or detergents, as they can damage the machine.Descaling is slightly different to cleaning – though no less essential in the long run. While cleaning should be done regularly, descaling can be done every 6-12 months to remove the build-up of limescale in your machine. This occurs because the water you use to make your coffee is full of minerals.
How long does descaling take for Nespresso?
To descale your Nespresso Vertuo machine, you will need to allow about 20 minutes for the process and the descale mode cannot be interrupted or exited. If the descaling light is still on, the machine hasn’t been rinsed with enough water after using the descaling agent. We recommend that you flush the machine with fresh water. Remove the water tank from the machine and fill it to the ‘max’ mark with tap water. Go to ‘settings’ and rinse the machine with water.To activate Descale Mode, begin with the brewer plugged in and powered off, then press and hold the 8oz and 12oz buttons together for 3 seconds. When flashing, press the BREW button to start the descaling process. Once the brew is complete, pour the hot liquid into the sink.To exit descaling mode, press and hold all three cup buttons for at least 3 seconds. You will hear a short beep. Empty and rinse the water tray and capsule container before placing back onto the machine. The machine will stop when the rinsing is complete.Simultaneously press and hold both cup buttons for 3-5 seconds to exit descaling mode. The lights will become steady or slow down and then become steady. Empty and rinse the capsule container, water tray and drip tray before reassembly.
How do I reset my Nespresso descaling light?
Hold the lever and top button simultaneously for about four seconds until the orange light turns into a green light. That’s what you’re hoping for. Turn the machine off by holding the lever down for about three seconds. Tap the top button to turn it on, and hopefully, you’ll see a green light. To enter descaling mode, press and hold all three cup buttons for at least 3 seconds. A short beep will confirm and all the buttons will blink simultaneously. Refill the water tank with the used solution. Close the slider to start descaling.To exit descaling mode, press and hold the button and the lever at the same time for 3 seconds, or until the light becomes green. Allow the machine to rest for 10 minutes.To exit the descaling mode before final validation with the temperature dial, open slider or machine goes back to stand-by mode automatically after 30 seconds.To exit descaling mode, press and hold the button and the lever at the same time for 3 seconds, or until the light becomes green. Allow the machine to rest for 10 minutes. The machine is now ready for use. The orange light will blink once every 2 seconds.