How do you reset a coffee maker?
Simply turn off the machine, unplug it from the power source, wait a few minutes, and then plug it back in. This can help reset the coffee maker and potentially resolve any temporary issues. To reset the machine to the default 1 CUP and 2 CUP shot volumes, press and hold the PROGRAMME button until the machine beeps three times. Release the PROGRAMME button.To reset the machine to the default 1 CUP and 2 CUP shot volumes and espresso water temperature press and hold the PROGRAM button until the machine beeps three times. Release the PROGRAM button. The machine will return to its original default setting.To reset the machine to the default 1 CUP and 2 CUP shot volumes and espresso water temperature press and hold the PROGRAM button until the machine beeps three times. Release the PROGRAM button. The machine will return to its original default setting.
Why is my coffee machine turning on but not brewing?
If your coffee machine is powering on but not brewing, the culprit might be a blocked water line or heating element. Mineral buildup from hard water can clog these components, preventing the water from reaching the right temperature or flowing into the brew basket[^2^]. Make sure the water reservoir of your Breville espresso machine is properly aligned and filled. A full and correctly positioned tank is crucial when it comes to its performance; even a slight misalignment can impact the entire brewing process. For the best results, use fresh, clean water.Whether it’s a drip coffee machine or a single-serve coffee machine, slow or no water flow is the most common problem with all home coffee machines, and there are a few causes behind this problem. Firstly, the water tank might be out of place.A very common issue for the Barista Express is where the water won’t come through the group head (the bit that you connect the porta filter to) when making coffee. Usually the steam-wand and hot water outlet are still working (sometimes they are not working either).
Why is my descale coffee machine but the light still on?
If the descaling light is still on, the machine hasn’t been rinsed with enough water after using the descaling agent. We recommend that you flush the machine with fresh water. Remove the water tank from the machine and fill it to the ‘max’ mark with tap water. The descaling cycle was interrupted If you have stopped it earlier, the light will stay on or keep flashing. In this case, turn off the machine and start the descaling procedure again and let it run till the end. After this the calc light should turn off automatically.The orange light will blink throughout the descaling process. The solution will disperse in stops and starts. The machine will stop automatically when the cycle is complete. When the descaling cycle has finished, proceed with a rinsing cycle.